Jeep Gladiator Stroke Speed Bump 2 Inch and Progressive Bump Stop Kit-Front and Rear 2.5-3.5 Inch Lift For 20-Pres Gladiator TeraFlex

TeraFlex Bump Stop Kits add additional protection to your suspension over the factory bump stops, which can deform during hard compression and suspension movement.

Our innovative bump stops meet the demand of high-performance driving. Composite construction combined with a progressive nature reduces suspension compression impacts and harshness when bottoming out whether driving off-road or on poorly maintained highways.

Reducing this impact increases driver ability to maintain vehicle control as well as reduces the risk of bending an axle housing tube. These maintenance-free bump stops don't require any adjustment or tuning.

SpeedBump Bump Stops feature a self-lubricating Delrin acetal resin polymer shaft to withstand 1,000s of continuous cycles without wear or abrasion. The external shaft seal also prolongs shaft life by wiping and cleaning the shaft to prevent contaminants from entering the SpeedBump housing.

Foam Progressive Bump Stops are constructed from a performance-tuned high-density closed-cell nitrogen charged microcellular polyurethane technology that will not fade or dissipate under extended heavy use to maintain its progressive nature.

This material is unaffected by temperature extremes and retains its flexibility under thermal or sub-zero temperatures. These bump stops are a full 1.5 inch longer than stock.

Proper bump stop length and/or bump stop strike pad height is crucial for preventing damage to axle housing tubes, suspension components, shock absorbers, and fenders.

Front and rear bump stops feature a simple bolt-on installation. SpeedBump Front Bump Stops simply require removal of the factory bump stop bell. Progressive Bump Stops simply pop-in to the existing factory locations. SpeedBump Lower Bump Stop Strike Pads feature a simple bolt-on installation.
Fits:

• JT Gladiator (pickup)
• 2.5-3.5 inch Lift

Includes:

• 2 inch-Stroke SpeedBump Kit - Front (2.5-3.5 inch Lift) (part number 1953752)
• 1.25 inch SpeedBump Bump Stop Pad Kit - Front Lower (part number 1467125)
• All necessary hardware
• Rear foam Progressive Bump Stops - pair
• 0.5 inch Bump Stop Strike Pad Shim Kit - Rear Lower (part number 1969100) x 2
• All necessary hardware

Features and Benefits:

• JT specific tuned for high-speed performance
• Foam Progressive Bump Stops simply pop-in to the existing factory locations
• Replaces factory foam bump stops
• Performance-tuned closed-cell nitrogen charged microcellular polyurethane technology
• Absorbs large impact energy progressively during compression to prevent bent axle tubes
• Prevents damage to suspension components, shock absorbers, and fenders
• Quiet movement and function (no pad-slap clunk)
• Maintains progressive nature during all conditions
• Will not fade or dissipate under extended heavy use
• Unaffected by temperature extremes - retains flexibility in thermal or subzero temps
• Resistant to all types of environmental conditions (mud, salt, sand, dust, etc.)
• Subzero temperature flexibility reduces fatigue
• Compatible w/ all suspension systems that retain factory axle spring mounting locations
• Maintenance-free, all composite construction
• Simple bolt-on installation
• Patented technology
• Limited lifetime warranty

Notes:

• Bump stop configuration varies depending on shock absorber collapsed length, tire size, and fenders - See instructions for proper configuration for your application.
• Install Time: 5 Hours (all 4)