Adding accessories to a work vehicle or off-road travel rig has never been more simple. By installing a sPOD switch panel up to 8 accessories can be installed on one Circuit Control Panel while only 1 cable has to be fed into the interior of the vehicle!
Say goodbye to running a positive, negative, relay and a ground for every single accessory. The sPOD system works as a fuse panel with solid-state circuit protection for up to 30AMPS per circuit for all of your accessories. No more worrying about what rated fuse to install either. The system will protect from 1.5 amps to 30 amps automatically.
The system utilizes automotive grade approved high-power, high-temp, ultra-reliable components with a maximum 100 amp capacity. The sPOD SourceSE is a fully programmable digital CAN-Bus controlled system utilizing state-of-the-art technologies.
sPOD's HD and SE systems have a Low voltage cutoff (LVCO) battery protection. The panel is designed to turn off after 2 minutes of the vehicle not running or if the voltage reaches 11.2 VDC. This is useful when you have accessories turned on while the vehicle is not running to ensure you will have enough cranking amps to start your vehicle. This feature can be disabled to run a fridge freezer while the vehicle is off.
The HD Switch Panel For 8 Circuit Systems is programmable via Bluetooth with any smartphone. With a book of 72 labels no matter what the switch panel is powering sPOD has a label for it. The most common uses are:
- Winch
- Bumper lights
- Air compressor
- Fridge freezer
- Rock lights
- Air compressor
- Lockers
- Spot lights
- CB Radio
OEM vehicle specific, simple installation hardware, engineered and 100% manufactured in the United States. Check out our sPOD inventory online or stop by the shop!
