JKS Control Arm Correction Bracket for 2007-2015 Jeep Wrangler JK

Reduced control arm angles allow the front suspension to more naturally roll over bumps and grooves in the road. Forces are better directed into the coil springs and shocks where they can be absorbed and controlled versus into the control arms and frame where they are felt more and create a less controlled handling feel (rough ride)

$175.00

1

JKS Control Arm Correction Bracket for 2007-2015 Jeep Wrangler JK

Double click on above image to view full picture

Zoom Out
Zoom In

Control Arm Correction & 2" Bump Stop Extension

  • Reduced control arm angles allow the front suspension to more naturally roll over bumps and grooves in the road. Forces are better directed into the coil springs and shocks where they can be absorbed and controlled versus into the control arms and frame where they are felt more and create a less controlled handling feel (rough ride)
  • Corrects caster for 2”-4.5” of lift. The new upper and lower control arm mounting holes are precisely positioned to provide the correct caster at the listed lift heights. The upper control arm mount provides two hole positions for proper caster settings through the full lift height range. The proper mounting locations for the installed lift heights are outlined in the installation instructions.
  • Improves the front drive shaft CV joint operating angles through full wheel travel. On 2012-2014 JK models, the new geometry increases clearance between the front driveshaft and exhaust at full suspension droop
  • Brackets are made from heavy-duty 7GA steel and are fully boxed and welded for superior strength when compared to bolt together 2-piece designs. The brackets install inside the factory upper and lower control arm mounts with the factory hardware. The heavy boxed construction, fully gusseted lower mount and welded crush sleeves give you extra confidence both on and off road.
  • The Control Arm Correction Brackets can be used with JKS adjustable control arms for the ultimate on and off road performance.

Important Notes:

  • Requires 2” of front bump stop extension for adequate clearance at full suspension compression. JKS 2” bump stop extension are available separately (#1120)
  • Can be used in conjunction with JKS or other aftermarket control arms that can be set to factory length.
  • Designed for use with 2”+ lift. Ideal lift range is 2”-4.5” but can be used up to 6”.
  • Do not combine with any other drop/relocation brackets

Vehicle Make

Jeep

Vehicle Model

Wrangler JK

Vehicle Year

2007, 2008, 2009, 2010, 2011, 2012, 2013, 2014, 2015

Special Fitment Notes

No special fitment notes.

Manufacture Part Number

JKS6200

Part Number

N/A

Free Shipping

Yes

Manufacturer

JKS

Installation Difficulty

Easy

Installation Instructions

Not Available

There are no reviews yet.
Be the first one who writes a review.

Post a New Review

You're reviewing: JKS Control Arm Correction Bracket for 2007-2015 Jeep Wrangler JK

Only registered users can write reviews. Please, log in or register

Compare Products

You have no items to compare.